How To Replace Control Panel On Ge Washer

How To Replace Control Panel On Ge Washer. About press copyright contact us creators advertise developers terms privacy policy & safety how. Flip the panel over and lay it on the top of the washer;

Washer Control Panel Part Number WH42X10899 Sears from www.searspartsdirect.com

You have to program the control board for the washer you have by selecting the appropriate binary display on the led's. As per instructions, to set model number to board press and hold temp and spin 3 second. There are also usually screws inside the soap dispenser drawer.

Source: www.searspartsdirect.com

To reset the electronic controls on your washer, shut off the circuit breaker or fuse to the washer or unplug the washer for 2 minutes. Reinstall the screw on the back right side of the control panel.

Source: diy-appliance-parts-store.com

Now you can just remove the 2 screws coming from the back side of the control panel and pry up on the plastic clips along the top of the control panel from the inside of the dryer and the control panel will pull forward and off. Using your photograph or other documentation as a guide, connect all the wires to the back of the new control board.

Source: www.ebay.com

Locate 2 spring clips between top and front panel (approximately 4 inches in from corners.) insert putty knife between top and front panel and push in to release clips. This will disengage the clip from the bolt head and allow removal.

Source: www.youtube.com

That information shown in the image is for a similar model so it may not work for your washer. You have to program the control board for the washer you have by selecting the appropriate binary display on the led's.

Source: www.ebay.com

Learn how to replace the main control board on your washer: These are on the right and left side of the machine.

Source: www.ebay.com

The start button is made into the control board so in order to replace, you have to swap out the whole board. Flip the panel over and lay it on the top of the washer;

Once The Screws Are Removed, Lift The Control Panel Up And Set It On Top Of The Machine.

That information shown in the image is for a similar model so it may not work for your washer. There are also usually screws inside the soap dispenser drawer. The image below shows some access information that you may be able to use for that model of ge spacemaker washer.

Insert The Mounting Screw In The Control Board Housing And Tighten It Firmly.

This procedure shows how to replace the machine control board (also known as the main electronic control board or mother board) in kenmore, kenmore elite, lg, whirlpool, maytag, samsung, ge and. We'll secure that main top, and now we're ready to put the front panel back on. Reconnect the air hose down to the back of the control board.

Then Push The Bottom Of The Front Panel Back Into Place Until The Two Lower Clips Snap Tight.

As per instructions, to set model number to board press and hold temp and spin 3 second. Retrieve the main top panel, and rest it on the washer while you pull. Reinstall the screws in the dispenser housing.

You Have To Program The Control Board For The Washer You Have By Selecting The Appropriate Binary Display On The Led's.

Push the detergent dispenser back into the. You can replace the front panel by pushing the front panel up under the edge of the top of the machine until the two top clips snap back into place. Using your photograph or other documentation as a guide, connect all the wires to the back of the new control board.

11 Replace The Screws To Secure The Control Panel.

Then, reattach the control panel trim and the washer’s rear panel. Plug in the wire harness connections for the control panel. For models that have a timer control knob, turn the knob around and back to any position other than final spin.