How To Test Ge Oven Control Board
How To Test Ge Oven Control Board. You will need to check to see if the voltage is present to the electronic oven control (eoc) board on the 15 pin connector. 1) shut off breaker for stove and confirm that panel lights go off 2) pull range away from wall about 12 3) shut off gas feed to stove 4) from the back of the range, remove the two hex washer head screw holding the in place 5) read more.
1) shut off breaker for stove and confirm that panel lights go off 2) pull range away from wall about 12 3) shut off gas feed to stove 4) from the back of the range, remove the two hex washer head screw holding the in place 5) read more. Test 4 push and hold broil broil element activate. I cannot find an internal fuse on the unit, so i suspect either the oven control board or the relay board is fried.
If The Readings Fall Between The Range Of 900 To 1200 Ohms, You Will Have To Get A New Oven Control Board.
If it did not help either then most likely the problem is a bad control panel, not the control board. Other than that, you would be looking at replacing a control board. Disconnect power to your range, then ohm test both limit switches for continuity.
To Replace The Control Board In A Ge Oven, Follow The Steps Listed Below.
Test 1 push and hold convection bake bake element and convection fan activate. There is power to the range and the control board does have some functionality, such as control pad signal and response, clock, on/off for all cook modes, but neither the bake or broil element will come on. Repairing control boards is impractical, so if this is the source of your oven's problems.
Think Of It As The Motherboard For A Computer.
Plug the oven back in and turn it on. Here's the steps from memory: There is the power to the control panel showing the time, red lights on showing burners, and the oven on.
If The Readings You See Are Either Lower Than 900 Ohms Or Higher Than 1200 Ohms, That Means The Temperature Sensor Should Be Replaced.
If it did not help then, with the power to the oven off, open the control panel and check the connection of the ribbon from the control panel into the control board. Answer rick, check your wiring connections at the terminal block on the oven, make sure there are no loose connections, you could be loosing power when the oven heats up. The clock and timer work.
If A Control Board Malfunctions, It Can Cause A Short Circuit.
1) shut off breaker for stove and confirm that panel lights go off 2) pull range away from wall about 12 3) shut off gas feed to stove 4) from the back of the range, remove the two hex washer head screw holding the in place 5) read more. I cannot find an internal fuse on the unit, so i suspect either the oven control board or the relay board is fried. The (eoc) should have 120vac when measured with a volt meter across pin 4 and pin 5.
Post a Comment for "How To Test Ge Oven Control Board"