How To Test A Control Board
How To Test A Control Board. The two ics don't appear to have markings. I connected motor to 12vdc and helped a bit to start.
You will need a volt meter to measure the voltages in your circuit. Open console and disconnect the keypad ribbon connection from the control (at p1). Use an identical circuit board that you know works to determine the right voltage levels.
When There Is A 24 Signal On The W Terminal Of A Furnace Control Board, The Board Should Allow Power To The Inducer Motor.
In the first method, the steps are pretty simple, and you will be able to test the system, such as; If the readings you see are either lower than 900 ohms or higher than 1200 ohms, that means the temperature sensor should be replaced. If you're measuring the resistance of resistors, connect one probe to each end of the resistor.
Compare The Measurements On The Working Circuit Board With The Voltages On The Circuit Board You Are Testing.
The real secret to control board troubleshooting is that there is no official test to prove that the control board is bad. For more details, you can check out the information below; The red probe goes to the test point and the black probe goes to ground or common.
It Is More About Knowing If The Control Board Is Controlling Components As It Should.
Place the sensor in the warm water container. Then i decided to test voltage on mcb motor pinouts and i was getting about 6vdc. Open console and disconnect the keypad ribbon connection from the control (at p1).
How To Know If Your Furnace Control Board Is Bad (9 Steps)
You will test for power coming to the power board 241708102 and then for power coming out of the board. The meter will apply a small voltage to make the semiconductor conduct and read that voltage on the screen. Most control boards use relays to switch on and off different parts such as the blower, ignitor, and gas valve.
You Will Need A Volt Meter To Measure The Voltages In Your Circuit.
You can also try pulling the power to the refrigerator entirely and then plugging it back in, effectively “resetting” the device. Indicates one or more key switch lines are stuck or shorted on either the control or the keypad. Make sure while playing out this step you have your hands on the plastic portion of the probes.
Post a Comment for "How To Test A Control Board"