Ecobee No C Terminal On Control Board

Ecobee No C Terminal On Control Board. So, you can simply strip the end of. Remove the wires from your old thermostat and connect them to their respective terminals on the ecobee.

No C Terminal in Control Panel (more details in comments from www.reddit.com

I rewired an ecobee 3 lite thermostat to a communicating furnace air handler control board. On the control board i have the following terminals: So, you can simply strip the end of.

Source: www.diychatroom.com

One group of wires goes to the fan. To download the complete ecobee3 lite installation guide please click here.

Source: www.diychatroom.com

Go back to the location of the old thermostat, and install the four wires into the ecobee wall mount as follows: Any help would be appreciated.

Source: www.reddit.com

Installing your ecobee thermostat with the power extender kit (no c wire) if you’re lacking a c wire and have at least four wires at your thermostat to work with (refer to this article if you only have two wires), you’ll want to install the power extender kit (pek). Without a c wire if you dont have a c wire youll need to use the power extender kit.

Source: www.reddit.com

Not all thermostats require a c wire, so it’s possible you have one but weren’t using it. Look where the control is connected to the b, g and y terminals.

Source: www.reddit.com

On the control board i have the following terminals: It may be blue or black.

Source: www.diychatroom.com

So, you can simply strip the end of. Below is a link to pictures from my current system:

On The Control Board I Have The Following Terminals:

Below is a link to pictures from my current system: From the other end of your pek, the y wire should be going to the y terminal on the hvac control board. So, you can simply strip the end of.

2) The Present Thermostat Was Install Back In 2011 When The Ac Unit Was Replaced.

I don't know if with my current setup an ecobee with pek would work so i wanted to seek advice from this subreddit. No c terminal on furnace ecobee. Without a c wire if you dont have a c wire youll need to use the power extender kit.

Check Your Junction Box For A Spare Wire That Was Pushed To The Back.

By dubaikhalifas on feb 3, 2022. Not all thermostats require a c wire, so it’s possible you have one but weren’t using it. Ecobee pek adapter installation without a board youtube.

Ecoboo Has Power Extender Kit But There's No Control Board On The Hvac Unit, So I Can't Locate A C Wire.

Fine, i'll use the pek. Ecobee pek adapter installation without a board. I found an ecobee wiring diagram for dual transformer systems and have attached that here.

No C Wire In Use.

By dubaikhalifas on feb 7, 2022. 1) on the furnace control board i tried to measure the voltage across the c terminal and each of the y w r g terminals and got 0 volts (even with the safety switch temporarily pressed on). There are two things i think that may have caused the fuse to blow.