Carrier Ignition Control Board Codes
Carrier Ignition Control Board Codes. Error code 14 will reset in 3 hours. This board replaces many older boards.
Power present + code 6 = bad ignition control board. The icm291 has incorporated led diagnostics to assist in troubleshooting. At the ignition control board (ic) check for 24vac between l and c.
Diagnostic Code # Xxxxx Checked Induced Draft, Pressure Switch, Blocked Vent Shutoff Switch, Flame Sensor & Rollout.
Loss of communication with the capacity control board: This means that the furnace control board failed to detect a flame or adequate flame, and has shut down. The icm291 dsi gas ignition control replaces the following carrier model:
Error Code 14 Will Reset In 3 Hours.
Main limit (located under burners) check for 24vac from each side of the limit (yel and blu) to c. Control board replacement, a step by step guide. The price of a new furnace control board starts from $50 and may range up to $250 depending on your furnace model.
This Category Contains Control Boards Manufactured By Carrier [Pool1] 350 Items.
Control board not calling for induced draft. 9 flashes is the draft motor/hall affect sensor failure. This is a sign of gas heating lockout.
Where Sometimes If The Flame Sensor Wire And The Spark Ignition Wire Are Seperated As Much As Possible, It Might Go Away.
Loss of communication with the economizer control board: At the ignition control board (ic) check for 24vac between l and c. What this means is that the furnace control board did not sense a flame or adequate flame and has shut down.
Cfm Led The Cfm Led Is An Indication Of Target Airflow.
Control will try three more times before lockout #14 occurs. The two faults are not related. It is indicating a fault on the indoor control board.
Post a Comment for "Carrier Ignition Control Board Codes"