Onan 5500 Control Board Location
Onan 5500 Control Board Location. Attach jumper between upper terminals 1 and 2. When we returned home and parked the mh in the driveway for cleanup i noticed an oil leak under the mh from the generator area.
On the generator push stop twice rapidly followed by one rapid push to start. Once you have the control panel off, you will see the controller inside the housing. The governor module is powered by way of the fuse on the control board.
We Have 20+ Year Old Fleetwood Pace Arrow Vision That Is Relatively New To Us.
I have an onan 5500 generator on my rv and am seeking some guidance. Do not start the generator. We just had a new control board and carb installed on our onan 5500 a month ago, i ran the generator for an hour or so then shut it down when we arrived at jekyll island campground.
Took It To A Mechanic Who Cleaned Fuel Varnish Out Of The Carb.
Remove it, and lift and pull the control panel away from the controller housing. On lp models, it controls the flow of lp gas to the throttle body. Remove wires from board's upper terminals 1, 2 and 3.
Locate The Voltage Regulator Inside The Generator's Control Box.
Tom from flight systems, inc. The engine control board or module controls the ignition, fuel pump, fuel solenoid (if equipped), field flash and starter. What the engine control board does.
Does The Control Board Dictate Whether A Newly Replace Fuel Pump Has The Ground Necessary To Allow The Fuel Pump To Run?
Onan 5500 marquis fuel pump question. Automatic generator start control hazards. If all above proves ok, the control board becomes a likely suspect.
It's Sensitive To Interference And Something Like A Bad Spark Plug Or Arcing From Wet Or Defective Spark Plug Wiring Can Make It Do Strange Things.
I have an onan marquis gold generator 5500, model hgjab that is in a winnebago adverturer 2002 motor home. The hgjab generator uses a microprocessor based control module. Generator runs fine but when i shut down the generator, all the power cuts off to but it keeps running.
Post a Comment for "Onan 5500 Control Board Location"