How To Test Maytag Oven Control Board
How To Test Maytag Oven Control Board. A faulty control board will not send voltage to the heating components. The range will not go into the self clean mode if you don't replace the door lock assembly but you should be able to use the bake and broil.
That provides general information on accessing and testing the control. I have traced it to ic uln2003an (16 pin, hole mount). The diagrams and parts for your model can be viewed at.
If It’s On, You Won’t Be Able To Use The Control Panel.
Video demo of automated test If the above checks test good and the relay on the board for the selected function is not closing replacing the control may be necessary. The maytag oven f1 error code indicates the touchpad or control board (clock) on your oven is faulty.
The F2 Code Means Your Maytag Oven Temperature Is Too Hot When You Set It On Bake, Broil, Or Clean.
The diagrams and parts for your model can be viewed at. So, for switching off the control lock function, look for the control lock button and push it for three seconds. Locate the ribbon running from the touch pad to the control board, and pull the end of the ribbon away from the control board to unplug it at the connector and disconnect it.
Maytag Refrigerator Ice Level Control Board.
Not surprisingly, neither are working. A rebuild has guaranteed results. If the readings you see are either lower than 900 ohms or higher than 1200 ohms, that means the temperature sensor should be replaced.
Most Times The Problem Is That The Speed Of The Key Presses Is Too Fast Or Too Slow.
We warranty our workmanship for 2 years on all our repairs; Revive your broken appliance even if the control board is obsolete or no longer available (nla) save money compared to buying new and get a longer warranty; Refer to your owner’s manual on how to test for a faulty touch pad and how to replace the touch pad, control board, or both.
This Part Is Often Misdiagnosed.
A faulty control board will not send voltage to the heating components. Securely pack your part and send it to us and once we receive it, our ipc certified technicians will run a test to identify the source of the problem. Then, plug the washer back into the power source.
Post a Comment for "How To Test Maytag Oven Control Board"