How To Test Gas Oven Control Board
How To Test Gas Oven Control Board. To test, remove the wires at the gas valve and ohm from the center terminal (common) to the upper one (broil); If your oven won't heat, test your oven's heating elements and confirm that the oven is receiving power before replacing the control board.
The most common reasons for replacing the oven c. Continuity should exist between these two terminals. There should be no continuity.
There Should Be No Continuity.
Check the wiring diagram to determine which two pins in the plug (not on the eoc) are connected to the oven sensor. Using your vom's ohmmeter function, set the range to r x 1 and touch one test lead to the terminal marked l and the other test lead to terminal h2. Other commonly replaced parts for an oven that won’t heat:
This Diy Repair Guide Explains How To Replace The Oven Control Board In A Gas Range.
I then replaced the cover to the control board then turned the breaker back on. The most common reasons for replacing the oven c. See that you are not carrying a tripped breaker in the main electric panel of your house.
There Is Power To The Range And The Control Board Does Have Some Functionality, Such As Control Pad Signal And Response, Clock, On/Off For All Cook Modes, But Neither The Bake Or Broil Element Will Come On.
Again, there should be no continuity. Locate the ribbon running from the touch pad to the control board, and pull the end of the ribbon away from the control board to unplug it at the connector and disconnect it. If the breaker continues to trip, you could have a wiring issue.
If The Sensor Measures The Proper Resistance And You Are Seeing The F10 At Room Temperature Then You Could Have A Problem With The Wiring Harness Or The Electronic Oven Control Board.
With the range still unplugged and the sensor plugged back in, you can measure the resistance through the violet wires that connect to the control board to check. If the readings fall between the range of 900 to 1200 ohms, you will have to get a new oven control board. You can replace the oven electronic control board yourself.
When The Oven Does Not Turn On Or Respond, You Should Check If It Has Been Properly Plugged Or Not.
These two wires provide the voltage to power up the electronic oven control board. Next, test the terminals marked h1 and h2. Frigidaire, ge, jenn air, kenmore, kitchenaid, magic chef, maytag, thermador, whirlpool.
Post a Comment for "How To Test Gas Oven Control Board"