Accutron 4 Control Board
Accutron 4 Control Board. Breckwell pellet stove control panels have been digital for many years. The earlier panels were made to turn the 4 rpm auger motors and 4 rpm augers and motors.
After a few years they switched to 1 rpm auger, auger motor with a 1 rpm control panel. Free shipping for many products! Unplug the 9 pin wire harness from the back of the board.
Free Shipping For Many Products!
We strive to provide opinions, articles, discussions and history related to hearth products and in a more general sense, energy issues. Add to cart $34.99 sku. The panel now says accutron iv and.
Connect The 9 Pin Molex Connector To The Control Board Making Sure The Connection Is Tight.
Unscrew the control board from the side of the heater (2 x 1/4” hex screws) 4. Install the thermostat module by plugging it into the 9 pin plug on the back of the control board. Custom control schematic for older pellet stove hearth.
Replacement Acutron 4 Digital Control Board For Glow Boy Pellet Stoves.
Glow boy pellet stove igniter freestanding and inserts. Order replacement parts for your pelpro product here. Replacement door gasket 3/4 x 60, fits pel pro pellet stoves that use the acutron control board.
Top Rated Seller Top Rated Seller.
In one case i had to replace a panel because the stove was not giving off enough heat. Unscrew the control board from the side of the heater (2 x 1/4” hex screws) 4. Repair service for all quadrafire pellet stove circuit board.
Active Since 1995, Hearth.com Is The Place On The Internet For Free Information And Advice About Wood Stoves, Pellet Stoves And Other Energy Saving Equipment.
Remove the 6 x 1/4” hex screws from the slotted back access panel 3. Place the new control board in the opening and replace the two 1/4 hex head screws. Unplug the 9 pin wire harness from the back of the board.
Post a Comment for "Accutron 4 Control Board"