Whirlpool Oven Control Board Not Working
Whirlpool Oven Control Board Not Working. If the interior lights still work but the control panel doesn't respond and the display is blank, either your control board behind the control panel has failed and needs to be replaced, or on some of these double oven models by whirlpool, there is a thermal fuse that plugs into the board on the right side. The display should show 1100 ohms of resistance.
Ok, then if thats the case, seems like the clock oven control board went out. I examined the board and saw that the 0.6amp fuse had blown. If your whirlpool super capacity 465 oven is not working, chances are there could be an issue with the electrical supply or that the control lock has been turned off.
If Playback Doesn't Begin Shortly, Try Restarting Your Device.
At room temperature, use a multimeter to test the sensor’s resistance. Normally when the breaker is first powered on the oven goes through a power on sequence. Whirlpool w71001799 range oven control board and clock genuine original equipment manufacturer (oem) part.
Since The Thermal Fuse Is Functioning Properly, This Symptom Should Convey That The Control Board Is Getting Power But Is Incapable Of Operating The Oven.
If your oven doesn’t work properly or have the following issues, replacing the oven electronic control board or main control panel could solve the problem. After unscrewing those, carefully unplug the ribbon cables connecting the components of the board and the rest of the oven. I examined the board and saw that the 0.6amp fuse had blown.
Visually Scan The Broil Element For Damage Or Signs Of Burning.
This repair service is for a whirlpool oven control board, part wpw10340304, that has failed and is experiencing the following issue: An oven with a damaged control board may not even power on at all. W10207928 membrane switch touchpad compatible with whirlpool oven.
Some Of The Indicators Of A Broken Control Board Are Not Quite As Obvious.
A bit of frustration set in at this point, so i checked the value of all the big resistors on the board. Oven does not reach temperature. I got a replacement keypad, however many of the keys still do not work.
Check If The Broil Element Turns Red When The Oven Is Running.
The display should show 1100 ohms of resistance. With the wires insulated from the light bulb so they wont touch and short against the any metal object (sometimes you and just tie them up), and then check the circuit input to the board again for the correct voltage to. Whirlpool oven not turning on?
Post a Comment for "Whirlpool Oven Control Board Not Working"